Tag Archives: MITSUBISHI PLC counter

Application of ladder diagram programming in MITSUBISHI PLC counter

MITSUBISHI PLC counter

The system input needs only one button and no output. Refer to figure 1, only X0. In Figure 3, (a), (b), (c), the current value of the counter is observed and the program execution process is analyzed.

The program M8011 is a special auxiliary relay. As long as the PLC is in operation state, it will send out 10 ms pulse signal (5 MS on, 5 ms off). In the program, T0 is 1s timing, 1s is closed after X0, and T0 is turned on. C0 is an increment counter, and the number of pulses emitted by M8011 is recorded on the premise that X0 is closed and T0 is not closed. Theoretically, when the T0 is turned on and the C0 counter stops counting, the current value of the counter should be 100 (1s/10ms = 100 pulses). In the three paragraph, it only changes the position before and after execution, but the result is different.

How to count the MITSUBISHI PLC counter

Parallel the Y0 and C0 at the output end. When the Y0 triggers the output once, the C0 will count once.
The counter must have a reset instruction. Technology completion triggers RST C1 reset
If you want to display the count times on the touchscreen, use the MOV command to send the C1 count to register D.
The display component of the touchscreen should select the display address, and the address is the D register you sent. For example, D1 D2 and so on. The display screen can display the data of the register.
The CD port of touch screen is the power supply interface, usually 24V DC. The communication port is the COM port. And that is to download the USB port. There is no technical port. Counting, timing and so on in PLC, all kinds of data are communicated through COM port.