Tag Archives: cnc motion control board

Best CNC Motor Driver Controllers 2018

CNC Motor Drive is a very important component of the CNC board, in fact the brain of the machine, can control one or more motors, please review the following 10 best CNC Motor Drive controller list, and in the comments section below tell us your favorite motor driver.

TB6560 3A Driver Board CNC Router Single 1 Axis Controller Stepper Motor Drivers

Working voltage DC 10V-35V. Recommended to use a switching power supply DC24V power supply.
6N137 high-speed optical coupling, guarantee high speed without losing step.
Using the TB6560AHQ chip with low voltage shutdown, overheating stop and overcurrent
protection circuit to ensure optimal performance.
Rated maximum output: ± 3A, peak 3.5A.
For two-phase within 42,57 stepping 3A / four-phase / of line four / six-wire stepper motor,
and is not suitable for more than 3A stepper motor.
Automatic half current function.
Subdivision: whole step, half-step, step 1/8, 1/16 step, a maximum of 16 subdivisions.

Available Here!

CNC Shield V3 3D Printer+4xA4988 Driver +UNO R3 For Arduino w/USB Cable

This expansion board as a driver expansion board, can be used for engraving machines, 3D printers.
It is a total of four slots, can drive four A4988 stepper motor. Each road stepper motors only need two IO ports. In other words, six IO ports can be well managed three stepper motors. Very convenient to use.
UNO for Arduino module IO port correspondence introduction.
Best choice for yourself or your friend.You will not be disappointed!

Available Here!

TB6560 4 Axis 3.5 A Stepper Motor Driver Board Controller Engraving

The controller comes with its own software that allows you to program the machine. The board runs on 12V power and can sustain a maximum of 3A current for the motors.

Available Here!

5 Axis CNC Breakout Board For Stepper Driver Controller mach3

Fully support of MACH3 and other computer software support for parallel port control.

USB power supply and peripherals powered phase separation to protect computer security. (USB cable not included)

Peripheral wide voltage input,12-24V, and anti-reverse function.
Available Here!

GRBL Laser controller board CNC USB 3 Axis Stepper Motor Driver Controller Board

This is a GRBL open source code-based laser, can be used for Laser Engraving machine, CNC Engraving Machine etc.

Available Here!

CNC TB6560 3.5A 4 Axis Stepper Motor Driver Board

The robust motor controller has the maximum current rating of 3.5A.  Additionally, it is equipped with over current and over-temperature safety features. The board is also fitted with closed-type optical isolation to protect the user’s computer and equipment.

Available Here!